Replies: 1 comment 1 reply
-
Unavailable status is normal when a parition is not ready ie has open zones. That's the status some of the home assistant like to see when a panel is not available to arm. If you don't like that status you can change it in dscalarm.h
Also note that it might take some time on initial startup for the firmware to know what the status of a zone/partition is until something changes to reset it. |
Beta Was this translation helpful? Give feedback.
1 reply
Sign up for free
to join this conversation on GitHub.
Already have an account?
Sign in to comment
-
After the initial struggle to get my setup going, everything has been running stable. But I do have 1 problem. It seems my partition status is unavailable (mostly when unarmed).
Partition 1 is almost permanently unavailable, except when the partition is armed. Partition 2 & 4 does change, like for example, partition 2 is currently disarmed while it was unavailable most of today. The only consistent partition is 3, but I suspect that is because it's permanently armed.
Do you have any advice? Anything I can check? I'm including logs (DEBUG mode) if it may help. Apart from this, everything else is working very well.
Thank you!
Beta Was this translation helpful? Give feedback.
All reactions