RE: Spindle PWM and GND and then Where to from that Point Forward

[silver2row]

Hello...can I use the spindle with the bare wires going to the T41U5XBB headers? If so, would PWM and GND do or would I need to populate the 0 to 10v trimpot?

Also, I have not been able to set up the mm * mm * mm for travel limits. Is there a particular section outside of the GRBL_HAL GUI in ioSender one can use to set up these limits?

I do not have hard limits, i.e. only soft limits.

Seth

[silver2row]

Oh and would I need a driver for the Spindle if using PWM and GND only?

Seth