| layout | title | permalink |
|---|---|---|
page |
Q113156: MS-DOS 6.2 Step By Step p.xxi: Install Does Not Make Backup. |
/kb/113/Q113156/ |
{% raw %}
Article: Q113156
Product(s): Microsoft Press
Version(s):
Operating System(s):
Keyword(s):
Last Modified: 05-FEB-2002
-------------------------------------------------------------------------------
The information in this article applies to:
- MSPRESS Microsoft MS-DOS Step By Step (covers versions 6.0 and 6.2), Printing 1
-------------------------------------------------------------------------------
SYMPTOMS
========
The "MS-DOS 6.2 Step By Step" (first printing) companion disk installation
program does not ask for a blank disk. This contradicts page xxi under step #3,
where the book says:
When asked to place a new blank disk in the drive, be sure to use a disk with
the highest capacity that your drive can handle.(For more details, refer to
"Identifying Types of Floppy Disks," in Lesson2.)
When the installation program runs, it never asks for a blank disk.
CAUSE
=====
The installation program does not make use of a blank disk. The paragraph below
step 3 on page xxi is an error in the first printing of this book, and should be
substituted with the information below.
RESOLUTION
==========
Ignore the paragraph directly below step 3 on page xxi. This paragraph is an
error in the first printing of this book. The installation program does not make
a backup as these instructions indicate.
A copy practice disk must be created. This disk will be referenced throughout the
lessons in the book.
To create a copy practice disk, complete the following step. (Current printings
have this step included as step 4.)
3.5 When the installation is completed, copy the practice files to a new
floppy disk. Insert a blank, formatted disk in the drive. If you're not
certain that the disk is formatted, follow steps 3 through 7 on page 21
before continuing. Then type the following commands, pressing the ENTER key
after each command. (If your floppy disk is in drive B, substitute B: for the
A: in these commands.)
XCOPY C:\SBS1STEP A:\SBS1STEP /S /E
XCOPY C:\SBSLESSN A:\SBSLESSN /S /E
XCOPY C:\SBSREV&P A:\SBSREV&P /S /E
After you enter each command, MS-DOS asks you whether you have specified a
file name or directory name. Press D for directory.
IMPORTANT: MS-DOS 6.2 Step By Step references the practice disk several times in
this book, so it is very important to complete the step outlined above.
STATUS
======
Microsoft has confirmed this to be a problem in "Microsoft Press MS-DOS 6.2 Step
By Step" printing 1. This problem was corrected in "Microsoft Press MS-DOS Step
By Step 6.2" printing 2.
MORE INFORMATION
================
An errata sheet is available from Microsoft Press Technical Support. The
information in the errata sheet is the same as the information provided in this
article.
Additional query words: "missing practice disk" SBS fail bad incomplete setup
======================================================================
Keywords :
Technology : kbMSPressSearch
Version : :
=============================================================================
{% endraw %}