Compatibility with Creality Ender 3 Pro v1.1.4

[gschanuel]

Hello there!
The Creeality v1.1.4 board is different from the one on the Wiki for Creality CR 10 Ender 3 so I just want to be extra sure, Is it compatible?

Also, Is there any difference between soldering the ESP32 on the CH340G pins or on the ATMega1284p?

Thanks in advance!

[gschanuel]

OK.. it was easy :-)
The hard part was to flash the firmware into the ESP-Wroom-32
Then I found which version of ESP32 Arduino Core I should use in the README,md and everything was fine

[liqijian101]

【3D打印机 ESP3D无线模块 可以匹配任何打印机主板 无需修改固件 脱机打印-哔哩哔哩】 https://b23.tv/PfhS8ES
I test this

[luc-github]

@liqijian101 is your new version of SD Sharing board ?

[liqijian101]

I can send you a set if you provide a forwarding address. Another disadvantage of this scheme is that if the motherboard does not have a serial interface,only have usb serial, it can not be directly connected to the USB serial port and requires a fly-wire to the CH 340 pin. I have always been able to make a direct connection to the USB serial module. I had already made a pic solution, but the PIC chip was too expensive, so I abandoned the PIC solution.

[liqijian101]

DM?
I’m sorry, I don’t know much about acronyms

[luc-github]

Direct Message ^_^

[liqijian101]

[luc-github]

@liqijian101 are you on https://discord.gg/e6zJ4aEU ?