Skip to content

Latest commit

 

History

History
50 lines (34 loc) · 2.08 KB

odroid-m1.md

File metadata and controls

50 lines (34 loc) · 2.08 KB

ODROID-M1

Home Assistant OS 10 and newer support the ODROID-M1 board.

SD-card

SD-card boot is supported via on-board bootloader (SPL) or recovery button.

eMMC

eMMC boot via on-board bootloader requires the latest version of Petitboot (spiboot 20230328). To install the latest version download the SPI boot image from linuxfactory.or.kr as follows:

  1. Download spiupdate_odroidm1_20220304.img.xz
  2. Use balenaEtcher or another tool to flash the updater onto an SD card
  3. Download spiboot-20230328.img
  4. Rename the spiboot-20230328.img file tospiboot.img.
  5. Paste the spiboot.img file onto the FAT partition of that same SD card.
  6. Plug-in that SD card to your ODROID-M1. Petitboot will update itself, you can verify the progress on the HDMI output.
  7. If you see the version 20230328 in the top right corner, the installation was successful.
  • If you see any other version there, the installation failed.

Once Petitboot is updated you can flash Home Assistant OS directly onto an eMMC.

NVMe

Booting directly from NVMe is not supported. The NVMe card can be used as a data disk.

Technical notes on boot flow

The Home Assistant OS image is bootable by the SoC directly. This means that no help from the Hardkernel provided and pre-installed bootloader Petitboot is necessary. However, the ODROID-M1 automatically boots from internal SPI. To boot directly off the SD-card or eMMC you need to press the recovery button.

The SPI flashed U-Boot SPL tries searches for an U-Boot binary on the SD-card (and from eMMC with Petitboot 20230328 and later). This mechanism allows you to boot the Home Assistant OS U-Boot without pressing the recovery button.

Console

By default, console access is available on the serial header (CON1) and on HDMI. The serial console's baudrate is 1500000 by default.

The systemd startup messages will only appear on the serial console by default. To show the messages on the HDMI console instead, add the console manually to the cmdline.txt file on the boot partition (e.g. console=tty0).