USB cable 5V red wire

[danylokos]

According to the README if I want to use USB lines I need to wire them like this to a spare USB cable:

USB cable D+ (green) -> L0p (color depends on your cable)
USB cable D- (white) -> L0n (color depends on your cable)
USB cable GND (black) -> GND

I have the same lightning cable as in the Hooking it up section, same colors match the same lightning pins.

So in my case I need to connect the additional USB cable like this:

USB cable green <-> Lightning cable white
USB cable white <-> Lightning cable green
USB cable GND <-> spare GND pin on pico

Do I need to connect the red wire of the USB cable to the pico as well? Don't want to burn the phone or the laptop accidentally 😅

And does the length of the USB cable metters here. I know that the lenght of the lightning cable matters - shorted is better, is that the same case for the additional USB cable?

[danylokos]

My spare USB cable also has this additional thick black Drain & Shield wire, not sure if it matters.

[VDavid003]

If you plan on using a seperate usb cable for usb data, I'd actually recommend wiring the lightning connectror's vbus to the seperate data usb's red +5v vbus line only instead of the rpi's vbus line. Checkm8 only works with this config for me. JTAG/DCSD will still work like this.

As for usb length, I think any usb cable that works as a regular usb cable just fine will work with it. I'm using a really short one but since it's just regular usb it should work with any standard usb cable's length I think.

[danylokos]

Huge thanks, worked like a charm! 😄👍