• Develop medical equipment
• Using built in libraries (liquid crystal, heart rate) of IDE and some major component Arduino, sensor and C++.
• Functionalities to check heart rate.
• Arduino uno
• PulseSensor max30100
• Jumper wire
• Breadboard
• Resistor 10kohm
• LCD 16 x 2
• First of All, Program is loaded in Arduino to read the signal from sensors.
• Connection of Pins is also defined in this Program.
• We will read data from serial port through default Libraries of IDE.
• Trigger is the input pin of Sensor which can be used to initialize measurement by transmitting pulse waves
• Whenever we place our finger over the sensor, Some output can be observed on LCD.
• Suspected heart attack (myocardial infraction).
• Presence of seizures.
• Monitoring of known cardiac arrhythmias.
• Medical monitoring when some kind of anesthesia is involved.
• Continuous or long-term monitoring could be done by Holter monitor
Circuit Diagram
Image of complete circuit
