iio: mxs: Implement support for touchscreen

This patch implements support for sampling of a touchscreen into
the MXS LRADC driver. The LRADC block allows configuring some of
it's channels into special mode where they either output the drive
voltage or sample it, allowing it to operate a 4-wire or 5-wire
resistive touchscreen.

In case the touchscreen mode is enabled, the LRADC slot imx6-dongle#7 is
reserved for touchscreen only, therefore it is not possible to
sample 8 LRADC channels at time, but only 7 channels.

The touchscreen controller is configured such that the PENDOWN event
disables touchscreen interrupts and triggers execution of worker
thread, which then polls the touchscreen controller for X, Y and
Pressure values. This reduces the overhead of interrupt-driven
operation. Upon the PENUP event, the worker thread re-enables the
PENDOWN detection interrupt and exits.

Signed-off-by: Marek Vasut <[email protected]>
Acked-by: Dmitry Torokhov <[email protected]>
Signed-off-by: Jonathan Cameron <[email protected]>

Documentation/devicetree/bindings/staging/iio/adc/mxs-lradc.txt

@@ -5,6 +5,12 @@ Required properties:
 - reg: Address and length of the register set for the device
 - interrupts: Should contain the LRADC interrupts
 
+Optional properties:
+- fsl,lradc-touchscreen-wires: Number of wires used to connect the touchscreen
+                               to LRADC. Valid value is either 4 or 5. If this
+                               property is not present, then the touchscreen is
+                               disabled.
+
 Examples:
 
 	lradc@80050000 {