You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
This file contains bidirectional Unicode text that may be interpreted or compiled differently than what appears below. To review, open the file in an editor that reveals hidden Unicode characters.
Learn more about bidirectional Unicode characters
@@ -26,7 +26,7 @@ You need either the Sipeed Tang Primer 25K or Tang Nano 20K FPGA board to run th
A [step-by-step instructions](https://github.com/nand2mario/snestang/blob/main/doc/installation.md) is available for installation. Here are quick instructions for the more experienced,
* Tang Primer 25K needs 4 modules: Tang sdram, DVI, Dualshock2, SD and a pair of dualshock controllers. Currently these should cost ~$60 in total. Tang Nano 20K just needs controller adapters. Check [instructions]([doc/installation.md](https://github.com/nand2mario/snestang/blob/main/doc/installation.md)) for how to connect the modules / adapters.
* Tang Primer 25K needs 4 modules: Tang sdram, DVI, Dualshock2, SD and a pair of dualshock controllers. Currently these should cost ~$60 in total. Tang Nano 20K just needs controller adapters. Check [instructions](https://github.com/nand2mario/snestang/blob/main/doc/installation.md) for how to connect the modules / adapters.
* Download a NESTang release from [github](https://github.com/nand2mario/nestang/releases). The bitstream (`nestang_*.fs`) should be written to flash at address 0. The firmware (`firmware.bin`) should be written to 0x500000 (5MB).
* A MicroSD card to hold ROMs.
* Connect one or two DualShock2 controllers to the DS2 pmod. Or you can connect one USB gamepad to use the [experimental USB gamepad support](doc/usb_gamepad.md). The board only has one USB port. So use DS2 if you want two players.
